Custom designed clay cutters with endless possibilities. CMarie Clay cutters are durable, uniquely designed, and sharp for clean edges and less sanding.

Material:
They are each uniquely designed with an additional reinforced wall with a very sharp 2mm cutting edge. Our imprint depth is 1.5m and designed to emboss clay beautifully. Each cutters is made with a grey marble PLA + filmanet which is a biodegradable material and tough; however, it can break if gets to hot so keep away from extreme temperatures. No dishwashers, hand wash only.

How to use:
Roll out your clay preferably on an oven safe ceramic tile to prevent sticking. Insert the cutter into conditioned clay and gently wiggle and remove. You can use cornstarch, water, or Saran Wrap to help with sticking as well. They can be smoothed with your fingertips or sanded after baking. Due to they sharp edge of the cutters minimal sanding is necessary, but depending upon design some finished pieces may require sanding.

Custom designed transfer sheets for polymer clay. Can be used with trinket dish designs as well. A single sheet will get you one trinket on most designs.

Each Sheet is approximately 4 x 5 inches

Purchasing Options:

Individual Sheet x1 (4x5inch)

Whole Sheet x4 (4x5inch)

How to Use:

1. Condition your clay (preferably white pattern shows up best on white)

2. Cut out how much you need of transfer and place face down on the clay and burnish. Be sure there is no bubbles or lifting

3. Immediately using a spray bottle soak the paper, then using blunt edge of your blade remove the paper

4. Then to remove any extra you can run cool water over the clay and using your finger gently rub the excess paper off the top.

5. Cut out your clay to desired shapes

6. Bake as normal and seal with your favorite varnish or resin.